Why is my TiPro9000 1TB stuttering in Control 2?
Entering the Federal Bureau headquarters was a nightmare; the screen would just go dead for three seconds, completely killing the immersion. Even though the TiPro9000 boasts sequential reads up to 7000MB/s, the controller response times were jumping wildly between 12-28ms when handling fragmented textures. I tried disabling the write cache in system properties first, but that was a disaster—load times spiked from 8 seconds to 22 seconds. I eventually flashed the latest firmware and used a partition tool to recalibrate the 4K alignment. Checking Resource Monitor, the disk active time finally dropped from a constant 100% peak to a manageable 42-58% range. I actually hit a scary moment where the drive disappeared from the system while tweaking driver priorities, but disabling PCIe Power Management fixed it for good. Now, temps sit at 48-54℃ with latency locked at 0.8-1.2ms. CrystalDiskMark confirms no more random spikes, and frame times are steady at 5.1-6.4ms.
