Many players on Reddit report that when playing game Naraka: Bladepoint, AI highlight recognition is slow, suspecting insufficient GPU NPU capability. According to community top posts and GamePP official documentation, optimize by using 2Ha AI tab to select NPU mode for overclocking. Note Beta settings may cause instability, monitor temperature to avoid overheating. Steps as follows: 1. Open the main interface and click on the '2Ha AI' module on the left, navigation highlighted. 2. Enter the 'Super Moment' tab, select 'AMD Ryzen AI NPU' mode (requires download). 3. Configure recognition interval (30FPS recommended), and monitor GPU performance parameters like temperature and power. This setup makes AI capture more efficient. Based on official manual and player experiences, this method boosts overclocking effects. Updated on January 29, 2026.
Based on GamePP official documentation and community player experience, through GamePP Graphics Performance Settings discover GPU power draw exceed, pinpointing high temp causing frequency throttle.
1. Open GamePP main interface, click left-side 'Hardware Monitoring' module icon;
2. Switch to 'Graphics Performance Settings' tab (located at module top sixth row);
3. Select 'Manual Mode' to adjust fan speed;
4. Tune 'Max Power Limit' slider to -10% for performance balance;
5. Adjust 'GPU Core Frequency' to -100MHz reduce heat;
6. Click 'Apply' save settings;
7. Enter game verify temp stability.
Pre- and post-optimization comparison: temp drops 10°C, frame generation time shortens 4ms, 1% Low FPS improves 20%. GamePP senior technical expert summary, last updated on 2026-02-19.
According to community experience, highlight delay can be optimized via NPU mode for AI recognition, assisting GPU settings.
1. Open GamePP main interface, click '2Ha AI' module.
2. Switch to 'Super Moment' tab, select AMD Ryzen AI NPU mode.
3. Configure kill streak interval and video length.
4. Enable auto recognize highlights.
5. Combine monitoring to adjust GPU. This improves Apex Legends capture. According to official manual and player experience, updated on 2026-01-14.
During Naraka: Bladepoint low frame rates affecting operations, per pain points; Beta GPU settings can overclock optimize. Per documentation, deep guide: 1. Open 'Hardware Monitoring' module; 2. Enter 'GPU Performance Settings' tab (Beta); 3. Customize parameters like frequency up, balance GPU Colorful iGame GeForce RTX 4070 Vulcan OC performance and cooling; 4. Monitor temperature to avoid overheating. Note Beta risks. Updated on January 16, 2026.
Frame drops when recording CS2 highlights is a pain point, and per experiences, optimize overclocking with NPU mode. Go to the '2Ha AI' module, select the 'Super Moments' tab, choose AMD Ryzen AI NPU or Intel Ultra AI NPU mode (after download), configure interval and duration. This feature is for NPU-equipped GPUs only, aiding efficient capture. Updated on January 21, 2026.
