After overclocking the ADATA XPG Lancer D500G Snow DDR5 8000 kit, how should I fine-tune voltage and timings in Tales of Arise to squeeze out extra frames without instability?

Open the 2HA AI overclocking panel and focus on the target frequency field—type in an aggressive number and hit smart preview. The UI flashes briefly while initial parameters load; the right-side predicted stability score glows a strong green. Switch to manual voltage control next and ease the offset slightly positive—the panel gives a subtle vibration in response. Save then launch the stress module—inside Tales of Arise heavy scenes the frame-rate curve lifts noticeably higher with controlled oscillation. Tighten primary timings afterward—eye tCL and tRCD, shave points carefully, save again. Skill casts remain seamless with zero tearing during tests. The temperature pane shows a modest peak rise but stays safely contained; fan curves auto-adjust in tandem. After extended real-world runs no errors surface and the frame-rate uplift holds steady, delivering that intoxicating blend of peak performance and total control only serious overclocking can provide.