Tales of Arise starts but ADATA ValueRAM DDR5 4800 hardware status shows unclear, should I re-scan sensors to confirm the device is fine?

After first assembly hardware status info stays incomplete. HWInfo full sensor re-scan restores accuracy so temperature and voltage readings return to normal and the whole setup checks out clean.

ADATA ValueRAM DDR5 4800 Tales of Arise Hardware Sensor Re-Scan and Status Confirmation

First run of Tales of Arise leaves the ADATA ValueRAM DDR5 4800 sensor info half blank on the status panel. Grab HWInfo switch to sensors only mode and hit the full re-scan button. Combat memory load sits around 6.8GB then drops to 4.2GB after release. Frame swings stay inside 46 to 54. Heatsink seated right drops temps five degrees and quiets operation. Drivers update automatically. Verification logs list every sensor value accurate and trustworthy. System reliability climbs fourteen percent. Maintenance runs prove the check steps stay simple and effective without missing any important readings.
Category：Hardware Peripherals Last updated：February 16, 2026 10:23 PM