Why does my Galax B760M D4 Wi-Fi stutter during scene transitions?
The scheduling logic on this board is basically a lottery; every time a map loads, the frequency bounces wildly between 3200MHz and 2133MHz, which often leaves the loading bar stuck at 99% for ages. I noticed the voltage on the Galax B760M Black Knight was swinging by 0.1V during these low-to-high load shifts, causing the memory controller to reset and dragging a 10-second load out to 30 seconds. I tried unplugging every single peripheral except the mouse, which was a total waste of time and solved absolutely nothing. I finally hit the BIOS, swapped the memory voltage from Auto to a manual 1.35V, and killed the power-saving modes. Checking with CPU-Z, the frequency is now dead-locked at 3200MHz, and loading times are back to normal. I did run into a scare where temps hit 60℃ after locking the voltage, but adding some tiny heatsinks brought it down to 50-55℃. Latency is now a steady 75-80ns. I exported the scheduler error logs from the Event Viewer to verify, and fan speeds are idling at 1400-1600RPM.
